HP Deskjet 3632 First Time Printer Installation

Quick HP Deskjet 3632 Unboxing Setup

• The contents of the box may vary depending on your region. Check the back of the box to know what's inside.
• Take out the 123.hp.com/dj3632 printer from the box and place it on a flat surface. Remove the plastic tape from the body of the printer.
• Lift the scanner lid and remove the packing material from the scanner. Remove the plastic sticker from the control panel.
• Remove all the plastic tape from the input and output trays and push them back into place. Recycle the plastic tapes. Connect one end of the power cord to the back of the printer and the other end into the power socket.
• Turn on the printer and select the preferred language and select the country and click yes to save. Set the date and time if needed. To install the cartridges, take them out of the box and remove the plastic tape from it. Open the cartridge access door and wait until the printer is idle.
• Hold it by the side and twist the orange cap to remove it. With the copper contacts facing forward install the cartridge into place.
• Follow the same procedure to install the other cartridge. To load the paper into the paper tray, pull out the input tray to its maximum.
• Adjust the paper width guide and slide the stack of paper into the tray and push it in until it stops. Adjust the paper width guide accordingly.
• Push the input tray back into place. To align the cartridge, place the alignment page on the scanner and close the lid.
• Click the scan option and the 123.hp.com/dj3632 printer will align the cartridge inside. Download the printer software to start using the printer.