Are you looking forward for unboxing your new HP Laserjet Pro M29w printer? Just read and follow the upcoming instructions to set up your printer.
- Go through the steps here to carry out the HP LaserJet Pro MFP M29W unboxing setup.
- Take out the 123.hp.com/ljpm29w printer from its box. Open the access door of the cartridge and clear the packaging tapes from that area.
- Remove the toner cartridge and then take out the clips from it.
- Hold the sides of the toner cartridge and rock it in the forward and backward direction to distribute the toner.
- Pull the orange label to take out the sealing tape from it.
- Align the toner cartridge with the tracks in the 123.hp.com/ljpm29w printer and push it until it is properly seated.
- Close the toner cartridge access area. Load the plain papers in the input tray by pulling down the output tray.
- Pull out the input and output tray, and load a stack of plain paper in the input tray with the short end forward and the print side up.
- Push in the stack into the tray until it stops. Slide in the paper width guides that they rest against the edges of the paper. Do not push them very far.
- Attach the electrical plug to the back of your printer and attach the other end of it into an electrical socket. Turn it on. Now, download and install the most recent version of the printer software and go with the prompts.
No comments:
Post a Comment